Small excavator rubber track is an important part of the excavator, which can effectively improve the service life and work efficiency of the excavator. Proper installation of rubber track can not only prolong its service life, but also ensure the safety of the excavator and avoid accidents during the working process. The installation method of the rubber track of the small excavator is introduced below.
1. Preparations
Before installing rubber tracks, preparatory work is required. First of all, it is necessary to check whether the specification and model of the rubber track match the excavator. Secondly, it is necessary to check whether the tires of the excavator are clean and whether there are foreign objects. Finally, the tires need to be inspected for damage or wear and replaced if necessary.
2. Installation method
Step 1: Raising the Excavator
First, the excavator needs to be raised so that the rubber tracks can be installed. Raise the excavator high enough to install the rubber tracks.
Step 2: Remove the original track
Remove the original tracks, taking care not to damage the tires and hubs. If the original track is not damaged, it can be cleaned and maintained for the next use.
Step Three: Install New Rubber Tracks
Put the new rubber track on the tire and make sure everything is in the correct position. During the installation process, you need to pay attention to the following points:
Make sure the direction of the rubber track is correct to avoid problems during use.
Make sure the rubber track fits perfectly on the hub and avoids foreign objects.
Make sure that the tension of the rubber track is appropriate, too tight or too loose will affect the service life.
Step 4: Adjust the rubber track
After installation, the rubber tracks need to be adjusted to ensure proper tension. The specific operation method is as follows:
Adjust the tensioner: Use the tensioner to adjust the tension of the rubber track to an appropriate state.
Check the track: Check the track for damage or wear and replace if necessary.
Check the sprockets: Check the sprockets for damage or wear and replace if necessary.
3. Precautions
When installing the rubber track of a small excavator, the following points need to be paid attention to:
Make sure the rubber track is the right size and model for your excavator.
Make sure the rubber tracks are oriented correctly.
Make sure the rubber track fits perfectly on the hub.
Make sure the rubber tracks are properly tensioned.
Check the tracks and sprockets for damage or wear.
4. Advantages of installing rubber tracks
1. The rubber track has the advantages of shock absorption, noise reduction, wear resistance, high and low temperature resistance, etc., which improves the performance of the small excavator.
2. The rubber track has less impact on the road surface, which can reduce road surface damage and noise pollution, and protect the environment.
3. The assembly of the rubber track is simple, convenient and fast, which can improve the working efficiency.
Through the introduction of this article, you should understand the steps, precautions and advantages of installing rubber tracks on small excavators. Safety must be paid attention to during the installation process to ensure that the rubber track is closely combined with the sprocket and iron wheel to improve the working efficiency of the small excavator and reduce destructive and environmental losses.